Відео

So if I'm pulling assemblies from the junkyard, it seems like I could take a holesaw to the bumper cover and skip a lot of that fun.

Very helpful. I appreciate that and I have my lovely wife help me. Thanks.

The 2013 Ford Escape has got to be the worst designed vehicle I have ever had the displeasure of interacting with. Thanks for your vid.

Thank you so so much for the video. It helped a lot.

Thank you. I’m sure if I went to a car dealership or mechanic I would get reamed and they would do exactly this and charge me a butt load of money so thank you so much.

I have a 2016 ford escape se that has about 165,000 miles on it. I guess that's when the trans is set to explode? Anyway, when its cold, it seems to work. As it gets warmer, 1st gear doesn't want to click in right away. Moreover, there seems to be a mechanism that puts the throttle in idle. Any trans folks have any ideas?

Where do I get the fender vent?

Thanks for this

Had to do a brake flush on a 2017 Chevy Bolt, this worked perfectly. Thank you!

Very helpful! This was the fix I needed on my 2016 Escape. Thank you!

On a 2011 ford edge the camera was upside down, I did the master reset first and it didn’t work so I unhooked the battery and that didn’t work. So for the hell of it, I tried the master reset again and surprisingly it work.

Thank you so Much for posting this i need to replace my radiator on my 2014

When I drive mine I always have this shown just cuz I love looking at which tire is being used 😂

HONESTLY THE BEST VIDEO THAT EXPLAINS THIS! ALMOST BOUT THE ENTIRE SWITCHER BRAND NEW UNTIL I LOOKED UP & SEEN IT HAD A RECALL!

"Hope you never have to do this" - and here we are :)

Thank you

Appreciate you, bro

Perfect info, especially after I opened the wrong 'over fill' plug on the 1.6L Escape and let out too much fluid. found this video and the 10mm Hex was exactly what I needed.

Mine just did that and had to be towed home 50 miles thought it was going to be the worst transmission but you tubed it and found you thanks a whole bunch for that video. Gary Bennett 🎉

Ford has definitely let us all down on these eco boost and junk transmissions . I’m srry to say I’m leaving ford

Are the plastic snaps replaceable? Some of mine are busted. 4:30

Дякую за українську ❤

I ordered the same camera on AliExpress for $25, and it works perfectly for me! I can give a link to the camera

So if i have a spare key the car came with, i dont need to order anything from toms right? I just use the spare and then clear the mykey?

I dont have MyKey settings. Only Driver Assist, Vehicle, and Display. I bought this car used, its a 2018 Ford. The Volume Key limit is set TO TEN. I'm beyind frustrated. Nowhere has the right info to help me get this removed, not even the dealer.

I did allot of towing with my 2016 2.0, so I changed the trans fluid every 40,000 miles. At a 157,000 miles I traded it in for a 2023 Escape with the 2.0. This 2023 is full of technology which I am still figuring out. I am reading on the Escape 2023+ Facebook group that Ford is not going to build anymore Escapes after 2024, so maybe getting a lease turn in, in 2025-2026 would be a great deal.

Mann fkkk FORD worst company ever

I have replaced turbo, wastegate and solenoids. Still getting code. I would be grateful for any help you can give im at a loss

Thank you!

not only was the battery replacement a nightmare but the wipers got kicked out of sync too....who designed this car jeez

Thanks! Was easy. Did not even need a screwdriver. Just hand.

Great

How to escape the Escape: get rid of it

Thanks!

Thank you I was surprised to see that it’s only 20 $ I’ve been driving a couple years without it. But I will definitely do it now 😎

Can I use atf fluid?

This is an older video, but I'll point a couple things out.... first off, you need to apply more silicone than that, and not just "in" the holes. You'll push that through with the screws. There needs to be some on the mating surface around the screw between the feet and the roof "around" the hole. These things are notorious for leaking. Also, you need to clean and inspect the whole channel between the feet. There is a hard sealant that has been painted over at the factory (there is a roof joint in that channel). Also known for happening is for that sealant to crack due to body flex and expansion/contraction, and you can usually see the paint cracked too. Inspect well, as you may need to reseal the entire channel, and you want to do that BEFORE adding the 3m tape covers.

Thanks for the data, I have the 2.0 ecoboost and I'm finding that after changing the solenoids on the bottom side with the brand new turbo and the top side with a new solenoid I've changed other sensors. Just not the ones that are connected to the throttle body because I'm under the impression on the 2.0 ecoboost it is a all-in-one unit. Any advice for me for my next step I would have greatly appreciate it

I have a 2014 ford escape titanium, would this work for it too?? I didn't know if there was a difference. I have the tools, need to buy the bushing. These cars are so difficult to work on with so much going on under the hood. You made this look straight forward and pretty simple! Appreciate this!

I was hit by a deer and dented my door. I was hoping to remove the interior door and pop the damage out. It doesnt look like that's going to be possible. Is that another barrier?

It works 🎉

Thanks a lot for the video man and all the info. I fixed my ford fiesta S 2015 with ur video. And those beautiful lug nuts fit on my ford fiesta too. Cheers 👌🙏🙏🙏❤️

Thanks , question once the air bag is out you think replacing the ford emblem is possible? The one I have it’s bent and damaged

Thank you for this video. Great detail!!

This was driving me insane. Thank you 🙏🏼

Thank you so much. The clips on the two sides I used never tightened, Not sure how to make them tight. On my 2018 Escape I did not have to take all the bolts out in the front (or rather push pins on mine) I was able to to wedge an end of my screwdriver to keep it open enough.

Thanks for the time dedicating to do this!

Well done! I have Liked and Subscribed, something that I rarely do. Very clear and concise, with a total lack of irritating background music! You saved me around $400 by enabling me to (easily) repair the car myself. I particularly liked your inclusion of bolt head sizes and torque specs.

The middle where it have that hump is there click in it or no?

Thank you